Network validating identity stuck
I had been able to connect previously, but the connection would always indicate that it was validating.
However, it didnt work, until I disconnected, turned the power off my Wi Fi, unchecked the tab in the authenticate dialog box, clicked ok, then switched the Wi Fi power back on, and reconnected.
I just installed a new wireless router and after entering the wireless SSID and password, I’m stuck at the status “Validating Identity”. The system is the following The schema on the top (the one with the random number as inputs) generates the training set, while the second one (with the ramp as input) is used to check whether the NN behaves properly.The network is a two layer network with a hidden layer of nodes and a linear output layer.I'm trying to connect my machine to a network over (wired) LAN.The connection (including internet) works fine in general, but when I open the "Network and Sharing Center", under "View your active networks" it only says "Identifying..." and the network name never appears. from the sound of it you did this: Windows Vista cannot obtain an IP address from certain routers or from certain non-Microsoft DHCP servers is that correct? But actually I just saw now that there is a message on that site that reads "Note: This issue does not occur in Windows 7.